With the change and development of The Times, the traditional low-speed mixing machine is gradually replaced by the high-speed mixing machine. Now let us explain the structure and composition of the high-speed mixer for you.

1, spindle: this part after fine grinding, fine car, quenching and tempering three processes, followed by tetrafluoroethylene, gas, skeleton type oil seal, after three processes of sealing does not leak powder.

2, mixing pot body: pot body is made of inner layer, outer layer, sandwich welding multi-layer structure, pot wall and pot bottom are made of stainless steel material, the inner surface is smooth and hard, with wear resistance, corrosion resistance.

3, stirring device: stirring device is composed of a plurality of impeller, installed in the same shaft at different heights, usually a group of two impeller.

4. Pot cover: the pot cover part is made of cast aluminum, its inner surface is polished and refined, and the exhaust port is equipped with filter device.

5, transmission parts: stirring blade is made of stainless steel, both wear resistance and corrosion resistance characteristics.

6, heating mode: heating mode adopts electric heating, heat transfer by heat conduction oil, impeller surface friction with the material and side thrust on the material, making the temperature rise;

7, unloading device: unloading device is made of aluminum alloy, and equipped with pneumatic unloading door, automatic feeding. At the same time, the cylinder and the discharge are linear connection, reliable compression, good sealing performance.